Cisco ios archive download-sw ftp command

Catalyst XR Switch Cisco IOS File System and Image Managment Configuration Guide, Cisco IOS Release (2)XE1 Command Purpose Step 1 archive download-sw [/directory] /overwrite /reload tftp: Copying Image Files Using FTP Caution For the download and upload algorithms to operate properly.  · I can´t run archive download-sw on the AP w because the command list doesn´t show it. The WLC I want to use has LWAPP image version APdfd1#? Exec commands: access-enable Create a temporary Access-List entry access-profile Apply user-profile to interface access-template Create a temporary Access-List entry.  · Catalyst X System Management Commands archive download-sw. To download a new image from a TFTP server to the switch or switch stack and to overwrite or keep the existing image, use the archive download-sw command in privileged EXEC bltadwin.rug-onboard: Specifies on-board failure logging.

If the switch port was configured by using the auto qos voip cisco-phone interface configuration command in Cisco IOS Release (37)SE or earlier, the auto-QoS generated commands new to Cisco IOS Release (40)SE are not applied to the port. I don't know if this is the correct forum for Cisco Switch command line management: I believe the command syntax you are looking for is:!!!! Advanced IP Services ((CORE)) archive download-sw /overwrite tftp://X.X.X.X /c Yea i have read the procedure on cisco stack switch ios transfer, does archive download-sw. I can´t run archive download-sw on the AP w because the command list doesn´t show it. The WLC I want to use has LWAPP image version APdfd1#? Exec commands: access-enable Create a temporary Access-List entry access-profile Apply user-profile to interface access-template Create a temporary Access-List entry.

Use the copy ftp flash command and follow the wizard. Configure the switch to load the new IOS version. Step 1: Switch#configure terminal Switch(config)#ip ftp username User Switch(config)#ip ftp password Password Switch(config)#end. Step 2: Switch#copy ftp flash Address or name of remote host []? x.x.x.x. I can´t run archive download-sw on the AP w because the command list doesn´t show it. The WLC I want to use has LWAPP image version APdfd1#? Exec commands: access-enable Create a temporary Access-List entry access-profile Apply user-profile to interface access-template Create a temporary Access-List entry. archive download-sw. Use the archive download-sw privileged EXEC command to download a new image from a TFTP server to the switch or switch stack and to overwrite or keep the existing image.